Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Churchville
Churchville homes with more than one fireplace, a wood stove insert, or a gas conversion in the same masonry stack have cap and crown needs that a single-flue job won’t cover. If water is reaching the family room during a hard rain, or a rusted cap is letting rain straight into the clay tile liner, call (855) 528-0951. We answer 24/7, fast dispatch runs 7am to 7pm Sunday through Friday, and the written estimate is free.
Why Churchville Homeowners Call Us for Chimney Cap & Crown
Churchville’s brick-and-siding colonials and center-hall two-stories usually run one masonry chimney that serves a wood-burning fireplace in the family room, sometimes with a second flue tied in for a wood stove insert or gas log set added later. That setup needs someone who can look at the whole stack, not just the flue they’re called about. We handle the sweep, cap and crown, liner, rebuild, and fireplace repair together, so the crown you need repaired and the cap you need fitted don’t get split between two contractors.
Technicians on these jobs have up to 8 years of experience with masonry crowns, multi-flue stacks, and the interior-wall chimneys common across Churchville. Many of the caps and crowns we fit are Gelco, Famco, or custom-fabricated units built to the actual flue count and rough opening, not a hardware-store cover sized by guesswork. If you’ve had a chimney swept by one company and then heard a vague warning about the crown from another, that split is exactly why this kind of thing stalls. One company across all five service categories closes it.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Churchville
Most of the cap and crown work in Churchville falls into four jobs. Here’s what each one involves.
Cap Installation
A properly sized cap is measured to the flue opening, not approximated. On the postwar and 1970s – 90s colonials around Churchville, the flue opening often ends up under a cap sized for a single flue, which leaves the second flue exposed if a stove insert was ever added. We measure the rough opening, fit a purpose-engineered Gelco or Famco cap, and seal the collar so rain, downdraft, and animal entry stay out. This is also the moment to check the crown and flashing, since the cap comes off to be measured anyway.

Cap Replacement
Rusted single-flue caps and caps that have blown off in a storm are a common find in Churchville, especially on chimneys set on an interior wall where nobody sees the roofline from the driveway. We pull the old cap, inspect the flue tile above the crown, and fit a replacement sized to what’s actually there. Custom caps are cut for irregular flue arrangements, which comes up often when a fireplace and a wood stove share one stack.

Crown Repair
Original mortar crowns from the 1970s – 90s build era crack at the flue collar, and freeze-thaw spalling of the brick face follows within a few seasons. Crown repair in Churchville means pulling the failed section, rebuilding the slope and overhang so water sheds away from the flue, and re-sealing the collar. On a shared-wall chimney, a crown that leaks often shows up inside the house before it shows on the roof, which is why we run a Level 2 inspection before recommending anything beyond a patch.

Crown Coating
Not every crown needs to come out. If the cracks are hairline and the crown is still structurally sound, a crown coating seals the surface and slows water absorption without a full rebuild. It’s the right call on crowns that are only starting to fail but not yet separated from the flue. We’ll tell you plainly when coating is enough and when it’s just delaying a rebuild. Call (855) 528-0951 for a written estimate.
Trusted Brands We Service in Churchville
We work with professional-grade components from Olympia Chimney, Famco, Gelco, and Copperfield. These are the brands commercial and specialty chimney contractors use, not the caps sold at a hardware store. When a cap fails on a multi-flue stack, the replacement needs to match the rough opening and the appliance load, which is why sizing matters more than brand name alone. We don’t keep parts on a truck or wait on a stocked shelf. We specify and order the correct cap or crown component for your stack, then fit it on the return visit. That’s how a Churchville chimney gets a cap sized for the flues it actually has.
Common Chimney Cap & Crown Problems We See in Churchville Homes
- Cracked mortar crowns at the flue collar. Original crowns from the 1970s – 90s build era in Churchville routinely crack where the flue tile meets the mortar. Freeze-thaw winters push water into those cracks, and brick spalling follows within a few seasons.
- Rusted or missing single-flue caps. A cap sized for one flue leaves a second flue exposed once an insert is added. When the chimney sits on an interior wall, a missing cap often goes unnoticed until water stains appear inside the house.
- Under-sized flues from gas or wood stove conversions. A gas log set or wood stove insert dropped into an original fireplace without a liner upgrade leaves a flue the old crown and cap were never sized for. The crown and cap still need to match the actual appliance load.
- Spalled brick face below the crown. Water soaking into the crown and seeping down the wall of the chimney breaks the brick face off over successive winters. Once spalling starts, the crown is the first place to check, since that’s where the water is coming in.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Cap & Crown in Churchville, PA
Pricing is per job by written estimate, and the estimate is free. Typical ranges for Churchville:
| Service | Typical range |
|---|---|
| Single-flue cap installation | $150 – $350 |
| Multi-flue cap installation | $250 – $550 |
| Custom cap fabrication | $400 – $900 |
| Crown repair (rebuild) | $450 – $1,100 |
| Crown coating | $200 – $450 |
What moves the price: flue count, whether the crown comes out or gets coated, accessibility of the roof, and whether the flashing needs re-sealing while the cap is off. A single-flue colonial with a straightforward cap runs toward the low end. A multi-flue stack with a separation at the collar pushes the crown repair higher. Nothing gets recommended that you haven’t seen on camera, and the written estimate sets the final price.
We Also Serve Cities Near Churchville
Churchville is one of the communities we serve across this part of Bucks County, along with Richboro, Feasterville, Somerton, and Lower Moreland. The same interior-wall chimney setup shows up across those towns, so the approach doesn’t change much from one to the next. For the full scope of what we handle, see our chimney cap & crown services, and for the broader area, see Churchville.
Serving Churchville, PA – Our Local Coverage Area
We serve Churchville and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Churchville
One flue, one cap. If the chimney serves only the family-room fireplace, a single-flue cap sized to that opening is enough. The multi-flue or custom cap comes in when the same stack has a second appliance, a wood stove insert, or a gas conversion sharing the chimney, which is common in Churchville’s larger colonials and split-levels. We measure the rough opening before specifying anything. Call (855) 528-0951 and we’ll tell you which one your stack actually needs.
You usually find out from the inside. Water staining, peeling paint, or a musty smell near the family-room fireplace is the first sign on a shared-wall chimney in Churchville, since the leak runs down the flue side of the wall where no one sees it from the driveway. We run a Level 2 camera inspection to find the source before recommending work, and you get the photo report to check yourself. If the crown is fine, we’ll say so.
It matters more, not less. A gas conversion or wood stove insert changes the flue the crown and cap have to serve, and a cracked crown still lets freeze-thaw water into the brick and the clay tile liner above the fireplace. That water damage happens whether or not the fireplace is lit. We check the crown, the cap, and the liner together on converted stacks so the whole system fits the appliance. Call (855) 528-0951 for a free estimate.
Once a year on a house with more than one flue or appliance, and a sweep whenever the wood-burning fireplace has had a season of use. Southeastern Pennsylvania’s freeze-thaw winters and humid summers are hard on masonry crowns, so a yearly look catches a hairline crack before it spalls the brick face. Fall is peak cleaning season here. Call (855) 528-0951 to book before the heating season fills.
Coating is the right call when the crown is still sound and only hairline-cracked. Once the crown has separated from the flue tile or the brick face below has spalled, it needs to be rebuilt, not just coated. The Level 2 inspection and photo report show you which one you’re dealing with, and the written estimate sets the price. Call (855) 528-0951 for an exact quote.
Book a Cap or Crown Estimate in Churchville
Call (855) 528-0951 for a free written estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Whether it’s a custom cap for a multi-flue stack or a crown rebuild on a colonial on an interior wall, we handle the whole chimney, not just the sweep, and nothing is recommended without camera evidence you can see for yourself.
Written by the team at Chimney Sweep Somerton.